1 Kings 7:31

31 The mouth of it inside the angle-plate was one cubit across; it was round like a pillar, a cubit and a half across; it had designs cut on it; the sides were square, not round.

1 Kings 7:31 Meaning and Commentary

1 Kings 7:31

And the mouth of it within the chapiter, and above, was a
cubit
On the lid of the base rose up a lesser base, called the chapiter, which was circular, like a coronet, as the word signifies, the inside of which was hollow, for the lower part of the layer to rest in; this ascended straight up half a cubit, and then widening, went up half a cubit more, and so in its whole height, as here a cubit; the circuit or circumference of which is called the mouth of the base, into which the feet of the layer were set, the measure of which is next given:

but the mouth thereof was round, after the work of the base, a cubit
and an half;
which was either the circumference or the diameter of it; one should think the latter:

and also upon the mouth of it were gravings, with their borders,
four square, not round;
though the mouth was round, the border of it was four square, which had figures engraved thereon, perhaps the same as on the other borders, lions, oxen, and cherubim.

1 Kings 7:31 In-Context

29 And on the square sides between the frames were lions, oxen, and winged ones; and the same on the frame; and over and under the lions and the oxen and the winged ones were steps.

30 Every base had four wheels of brass, turning on brass rods, and their four angles had angle-plates under them; the angle-plates under the base were of metal, and there were ornaments at the side of every one.

31 The mouth of it inside the angle-plate was one cubit across; it was round like a pillar, a cubit and a half across; it had designs cut on it; the sides were square, not round.

32 The four wheels were under the frames, and the rods on which the wheels were fixed were in the base; the wheels were a cubit and a half high.

33 The wheels were made like carriage-wheels, the rods on which they were fixed, the parts forming their edges, their rods and the middle points of them, were all formed out of liquid metal.