Parallel Bible results for 1 Kings 7

Holman Christian Standard Bible

New International Version

1 Kings 7

CSB 1 Solomon completed his entire palace-complex after 13 years of construction. NIV 1 It took Solomon thirteen years, however, to complete the construction of his palace. CSB 2 He built the House of the Forest of Lebanon. It was 150 feet long, 75 feet wide, and 45 feet high on four rows of cedar pillars, with cedar beams on top of the pillars. NIV 2 He built the Palace of the Forest of Lebanon a hundred cubits long, fifty wide and thirty high, with four rows of cedar columns supporting trimmed cedar beams. CSB 3 It was paneled above with cedar at the top of the chambers that [rested] on 45 pillars, fifteen per row. NIV 3 It was roofed with cedar above the beams that rested on the columns--forty-five beams, fifteen to a row. CSB 4 There were three rows of window frames, facing each other in three tiers. NIV 4 Its windows were placed high in sets of three, facing each other. CSB 5 All the doors and doorposts had rectangular frames, the openings facing each other in three tiers. NIV 5 All the doorways had rectangular frames; they were in the front part in sets of three, facing each other. CSB 6 He made the hall of pillars 75 feet long and 45 feet wide. A portico was in front of the pillars, and a canopy with pillars was in front of them. NIV 6 He made a colonnade fifty cubits long and thirty wide. In front of it was a portico, and in front of that were pillars and an overhanging roof. CSB 7 He made the Hall of the Throne where he would judge-the Hall of Judgment. It was paneled with cedar from the floor to the rafters. NIV 7 He built the throne hall, the Hall of Justice, where he was to judge, and he covered it with cedar from floor to ceiling. CSB 8 Solomon's own palace where he would live, in the other courtyard behind the hall, was of similar construction. And he made a house like this hall for Pharaoh's daughter, his wife. NIV 8 And the palace in which he was to live, set farther back, was similar in design. Solomon also made a palace like this hall for Pharaoh's daughter, whom he had married. CSB 9 All of these [buildings] were of costly stones, cut to size and sawed with saws on the inner and outer surfaces, from foundation to coping and from the outside to the great courtyard. NIV 9 All these structures, from the outside to the great courtyard and from foundation to eaves, were made of blocks of high-grade stone cut to size and trimmed with a saw on their inner and outer faces. CSB 10 The foundation was made of large, costly stones 12 and 15 feet long. NIV 10 The foundations were laid with large stones of good quality, some measuring ten cubits and some eight. CSB 11 Above were also costly stones, cut to size, as well as cedar wood. NIV 11 Above were high-grade stones, cut to size, and cedar beams. CSB 12 Around the great courtyard, as well as the inner courtyard of the Lord's temple and the portico of the temple, were three rows of dressed stone and a row of trimmed cedar beams. NIV 12 The great courtyard was surrounded by a wall of three courses of dressed stone and one course of trimmed cedar beams, as was the inner courtyard of the temple of the LORD with its portico. CSB 13 King Solomon had Hiram brought from Tyre. NIV 13 King Solomon sent to Tyre and brought Huram, CSB 14 He was a widow's son from the tribe of Naphtali, and his father was a man of Tyre, a bronze craftsman. Hiram had great skill, understanding, and knowledge to do every kind of bronze work. So he came to King Solomon and carried out all his work. NIV 14 whose mother was a widow from the tribe of Naphtali and whose father was a man of Tyre and a craftsman in bronze. Huram was highly skilled and experienced in all kinds of bronze work. He came to King Solomon and did all the work assigned to him. CSB 15 He cast two [hollow] bronze pillars: each 27 feet high and 18 feet in circumference. NIV 15 He cast two bronze pillars, each eighteen cubits high and twelve cubits around, by line. CSB 16 He also made two capitals of cast bronze to set on top of the pillars; seven and a half feet was the height of the first capital, and seven and a half feet was also the height of the second capital. NIV 16 He also made two capitals of cast bronze to set on the tops of the pillars; each capital was five cubits high. CSB 17 The capitals on top of the pillars had gratings of latticework, wreaths made of chainwork-seven for the first capital and seven for the second. NIV 17 A network of interwoven chains festooned the capitals on top of the pillars, seven for each capital. CSB 18 He made the pillars with two encircling rows of pomegranates on the one grating to cover the capital on top; he did the same for the second capital. NIV 18 He made pomegranates in two rows encircling each network to decorate the capitals on top of the pillars. He did the same for each capital. CSB 19 And the capitals on top of the pillars in the portico were shaped like lilies, six feet [high]. NIV 19 The capitals on top of the pillars in the portico were in the shape of lilies, four cubits high. CSB 20 The capitals on the two pillars were also immediately above the rounded surface next to the grating, and 200 pomegranates were in rows encircling each capital. NIV 20 On the capitals of both pillars, above the bowl-shaped part next to the network, were the two hundred pomegranates in rows all around. CSB 21 He set up the pillars at the portico of the sanctuary: he set up the right pillar and named it Jachin; then he set up the left pillar and named it Boaz. NIV 21 He erected the pillars at the portico of the temple. The pillar to the south he named Jakin and the one to the north Boaz. CSB 22 The tops of the pillars were shaped like lilies. Then the work of the pillars was completed. NIV 22 The capitals on top were in the shape of lilies. And so the work on the pillars was completed. CSB 23 He made the cast [metal] reservoir, 15 feet from brim to brim, perfectly round. It was seven and a half feet high and 45 feet in circumference. NIV 23 He made the Sea of cast metal, circular in shape, measuring ten cubits from rim to rim and five cubits high. It took a line of thirty cubits to measure around it. CSB 24 [Ornamental] gourds encircled it below the brim, 10 every half yard, completely encircling the reservoir. The gourds were cast in two rows when the reservoir was cast. NIV 24 Below the rim, gourds encircled it--ten to a cubit. The gourds were cast in two rows in one piece with the Sea. CSB 25 It stood on 12 oxen, three facing north, three facing west, three facing south, and three facing east. The reservoir was on top of them and all their hindquarters were toward the center. NIV 25 The Sea stood on twelve bulls, three facing north, three facing west, three facing south and three facing east. The Sea rested on top of them, and their hindquarters were toward the center. CSB 26 The reservoir was three inches thick, and its rim was fashioned like the brim of a cup or of a lily blossom. It held 11,000 gallons. NIV 26 It was a handbreadth in thickness, and its rim was like the rim of a cup, like a lily blossom. It held two thousand baths. CSB 27 Then he made 10 bronze water carts. Each water cart was six feet long, six feet wide, and four and a half feet high. NIV 27 He also made ten movable stands of bronze; each was four cubits long, four wide and three high. CSB 28 This was the design of the carts: They had frames; the frames were between the cross-pieces, NIV 28 This is how the stands were made: They had side panels attached to uprights. CSB 29 and on the frames between the cross-pieces were lions, oxen, and cherubim. On the cross-pieces there was a pedestal above, and below the lions and oxen were wreaths of hanging work. NIV 29 On the panels between the uprights were lions, bulls and cherubim--and on the uprights as well. Above and below the lions and bulls were wreaths of hammered work. CSB 30 Each cart had four bronze wheels with bronze axles. Underneath the four corners of the basin were cast supports, each next to a wreath. NIV 30 Each stand had four bronze wheels with bronze axles, and each had a basin resting on four supports, cast with wreaths on each side. CSB 31 And the water cart's opening inside the crown on top was 18 inches wide. The opening was round, made as a pedestal 27 inches wide. On it were carvings, but their frames were square, not round. NIV 31 On the inside of the stand there was an opening that had a circular frame one cubit deep. This opening was round, and with its basework it measured a cubit and a half. Around its opening there was engraving. The panels of the stands were square, not round. CSB 32 There were four wheels under the frames, and the wheel axles were part of the water cart; each wheel was 27 inches tall. NIV 32 The four wheels were under the panels, and the axles of the wheels were attached to the stand. The diameter of each wheel was a cubit and a half. CSB 33 The wheels' design was similar to that of chariot wheels: their axles, rims, spokes, and hubs were all of cast metal. NIV 33 The wheels were made like chariot wheels; the axles, rims, spokes and hubs were all of cast metal. CSB 34 Four supports were at the four corners of each water cart; each support was one piece with the water cart. NIV 34 Each stand had four handles, one on each corner, projecting from the stand. CSB 35 At the top of the cart was a band nine inches high encircling it; also, at the top of the cart, its braces and its frames were one piece with it. NIV 35 At the top of the stand there was a circular band half a cubit deep. The supports and panels were attached to the top of the stand. CSB 36 He engraved cherubim, lions, and palm trees on the plates of its braces and on its frames, wherever each had space, with encircling wreaths. NIV 36 He engraved cherubim, lions and palm trees on the surfaces of the supports and on the panels, in every available space, with wreaths all around. CSB 37 In this way he made the 10 water carts using the same casting, dimensions, and shape for all of them. NIV 37 This is the way he made the ten stands. They were all cast in the same molds and were identical in size and shape. CSB 38 Then he made 10 bronze basins-each basin holding 220 gallons and each was six feet wide-one basin for each of the 10 water carts. NIV 38 He then made ten bronze basins, each holding forty baths and measuring four cubits across, one basin to go on each of the ten stands. CSB 39 He set five water carts on the right side of the temple and five on the left side. He put the reservoir near the right side of the temple toward the southeast. NIV 39 He placed five of the stands on the south side of the temple and five on the north. He placed the Sea on the south side, at the southeast corner of the temple. CSB 40 Then Hiram made the basins, the shovels, and the sprinkling basins. So Hiram finished all the work that he was doing for King Solomon on the Lord's temple: NIV 40 He also made the basins and shovels and sprinkling bowls. So Huram finished all the work he had undertaken for King Solomon in the temple of the LORD: CSB 41 two pillars; bowls for the capitals that were on top of the two pillars; the two gratings for covering both bowls of the capitals that were on top of the pillars; NIV 41 the two pillars; the two bowl-shaped capitals on top of the pillars; the two sets of network decorating the two bowl-shaped capitals on top of the pillars; CSB 42 the 400 pomegranates for the two gratings (two rows of pomegranates for each grating covering both capitals' bowls on top of the pillars); NIV 42 the four hundred pomegranates for the two sets of network (two rows of pomegranates for each network, decorating the bowl-shaped capitals on top of the pillars); CSB 43 the 10 water carts; the 10 basins on the water carts; NIV 43 the ten stands with their ten basins; CSB 44 the reservoir; the 12 oxen underneath the reservoir; NIV 44 the Sea and the twelve bulls under it; CSB 45 and the pots, shovels, and sprinkling basins. All the utensils that Hiram made for King Solomon at the Lord's temple [were made] of burnished bronze. NIV 45 the pots, shovels and sprinkling bowls. All these objects that Huram made for King Solomon for the temple of the LORD were of burnished bronze. CSB 46 The king had them cast in clay molds in the Jordan Valley between Succoth and Zarethan. NIV 46 The king had them cast in clay molds in the plain of the Jordan between Succoth and Zarethan. CSB 47 Solomon left all the utensils unweighed because there were so many; the weight of the bronze was not determined. NIV 47 Solomon left all these things unweighed, because there were so many; the weight of the bronze was not determined. CSB 48 Solomon also made all the equipment in the Lord's temple: the gold altar; the gold table that the bread of the Presence was placed on; NIV 48 Solomon also made all the furnishings that were in the LORD's temple: the golden altar; the golden table on which was the bread of the Presence; CSB 49 the pure gold lampstands in front of the inner sanctuary, five on the right and five on the left; the gold flowers, lamps, and tongs; NIV 49 the lampstands of pure gold (five on the right and five on the left, in front of the inner sanctuary); the gold floral work and lamps and tongs; CSB 50 the pure gold ceremonial bowls, wick trimmers, sprinkling basins, ladles, and firepans; and the gold hinges for the doors of the inner temple (that is, the most holy place) and for the doors of the temple sanctuary. NIV 50 the pure gold basins, wick trimmers, sprinkling bowls, dishes and censers; and the gold sockets for the doors of the innermost room, the Most Holy Place, and also for the doors of the main hall of the temple. CSB 51 So all the work King Solomon did in the Lord's temple was completed. Then Solomon brought in the consecrated things of his father David-the silver, the gold, and the utensils-and put them in the treasuries of the Lord's temple. NIV 51 When all the work King Solomon had done for the temple of the LORD was finished, he brought in the things his father David had dedicated--the silver and gold and the furnishings--and he placed them in the treasuries of the LORD's temple.