1 Kings 7:30

30 Each stand had four bronze wheels with bronze axles and a basin resting on four supports, with wreaths at each side.

1 Kings 7:30 Meaning and Commentary

1 Kings 7:30

And every base had four brasen wheels, and plates of brass,
&c.] Flat pieces or planks of brass, on which the wheels stood, and not on the bare floor; so that these wheels seem only to serve as supporters, not to carry the laver from place to place, as is usually said; for they were not like chariot wheels, on two sides of the carriage, but set one at each square; and besides, when the lavers were placed upon them, they were fixed in a certain place, ( 1 Kings 7:39 )

and the four corners thereof had undersetters;
or "shoulders ^F1", or pillars, which were placed on the plates of brass the wheels were; and served with them to support the lavers when laid upon the bases, and so were of the same use as men's shoulders, to bear burdens on them:

under the layer were undersetters molten;
cast as, and when and where, the bases were, and the plates on which they stood; this explains the use they were of, being under the laver; these pillars stood at the four corners of the base:

at the side of every addition;
made of thin work, ( 1 Kings 7:29 ) they stood by the side of, or within side, the sloping shelves.

---

FOOTNOTES:

F1 (tptk) "humeri", Pagninus, Montanus

1 Kings 7:30 In-Context

28 This was the design of the stands: They had side panels attached to uprights,

29 and on the panels between the uprights were lions, oxen, and cherubim. On the uprights was a pedestal above, and below the lions and oxen were wreaths of beveled work.

30 Each stand had four bronze wheels with bronze axles and a basin resting on four supports, with wreaths at each side.

31 The opening to each stand inside the crown at the top was one cubit deep, with a round opening like the design of a pedestal, a cubit and a half wide. And around its opening were engravings, but the panels of the stands were square, not round.

32 There were four wheels under the panels, and the axles of the wheels were attached to the stand; each wheel was a cubit and a half in diameter.